《汽车风洞实验室校准方法》国家标准第二次工作会议顺利召开 The second meeting of the National Standard for Calibration Methods of Automotive Wind Tunnel Laboratoty was successfully held.
全国工业过程测量控制和自动化标准化技术委员会工业在线校准方法分技术委员会（SAC/TC124/SC7）主持编制的《汽车环境风洞试验室检验方法》国家标准（计划号20201401-T-604）第二次国标编制工作会议于2020年10月26日～28日在上海市、江苏常熟顺利召开，本次会议由苏州佐竹承办。
The second standard preparation meeting of the national standard "Rating Methods for Automobile Climatic Wind Tunnel" (plan number 20201401-T-604) prepared by the National TC124 On Industrial Process Measurement, Control and Automation of SAC - Industrial Online Calibration Method Subcommittee (SAC/TC124/SC7) was successfully held in Shanghai and Changshu, from October 26 to 28, 2020. The meeting was hosted by Suzhou Satake.
上海市计量测试研究院、上海机动车检测中心、上汽乘用车技术中心、中国汽车工程研究院股份有限公司、国家汽车质量监督检验中心（襄阳）、中国汽车技术研究中心有限公司、长安汽车工程研究总院、一汽研发总院、长春汽车检测中心、吉利汽车研究院有限公司、吉林大学空气动力研究所、中国计量科学研究院、上海交通大学、上海佐竹、苏州佐竹的专家代表出席会议。
SIMT, SMVIC, SAIC, CAERI, NAST (Xiangyang), CATARC, Changan Auto, FAW R&D Center, CATC, Geely Automobile Research Institute, Jilin University Aerodynamics Research Institute, NIM, Shanghai Jiaotong University, Shanghai Satake, and Suzhou Satake attended the meeting.
本次会议主要讨论并修订标准草案，会议上与会代表积极发言，对标准修订提出了宝贵的修改意见。本次标准工作会议上，与会代表一致认为，汽车环境风洞试验室标准项目意义重大，填补汽车环境风洞试验室校准方法的空缺，具有很强的指导意义。
The purpose of the meeting was to discuss and revise the draft standard. Participants actively spoke and put forward valuable comments on the standard revision. At this standard working meeting, the participants agreed that the standard project of the automotive wind tunnel laboratory is of great significance, filling the blank in the calibration method of the automobile climatic wind tunnel , and has strong guiding significance.
会议圆满结束后，各专家参观了承办单位苏州佐竹工厂。
After the successful conclusion of the conference, the experts visited the Suzhou Satake factory of the organizer.
